Studio build – Part III…
This could be described as a problem to say the least…
I have a computer at the studio for shooting tethered, browsing the net and listening to some tunes from Grooveshark.com.
When I got the computer there, I just connected the wires so that I could use it (get some music going) and thought that I’d tidy it up a bit later.
A bit later it is…several months later actually, but I finally got it done.
As you could see from the first photo, there already was a few holes at the back of the table, but I needed a few more to route the wires.
Next I fabricated a small shelf for the “subwoofer” under the table…
…and also added a hook for the USB extension cable.
I must say that a few holes, a few zip-ties, a bit of Velcro sticker and a lot of time do make a difference.
It’s quite a bit easier to push the table around now since there are no loose wires hanging anymore, so mission accomplished.
I still have to add an extension cord on the inside so that there’s only one electrical wire coming out of the table.
On a small side note, if you still remember these V-flats I made, they are now history.
They seemed like a good idea and don’t get me wrong, they did work really well when I was shooting on the seamless, but otherwise they were way too big and heavy.
I got tired walking around them all the time and they did take too much space in such a small studio so they had to go.
I’ll have to fabricate smaller and more importantly lighter versions of these at some point since I still need something like this for the seamless.
I have a few other things brewing at the studio also, so stay tuned for part IV.
Janne





